Advanced Tuning Settings

This page contains settings for the tuning device you have selected.

·	Device Name

If you chose Unlisted Remote in the previous step, enter a name for this tuning profile. You will need to select this name from a list later.

The rest of the settings on this page affect how Enterprise TV will use the remote to tune channels. Note: We recommend only changing these settings after determining that Enterprise TV is unable to properly tune the receiver box.

Proceed to Training.

·	Use Enter after sending channel request

Some set-top boxes will not change channels at all unless the user hits "Enter" or "OK" after entering the channel number. Enable this option if the set-top box for this Source behaves in this manner.

·	Pad Channels

Check this box to enable the Padding setting, described below.

·	Pad to how many digits?

Specifies the number of digits a set-top box requires to change channels. For example, a box may require the user enter "013" to get to channel 13; this corresponds to a "pad channels" setting of 3.

·	Pause between transmissions

The time, in milliseconds, that Enterprise TV should wait before sending the next button press when changing channels.

·	Repeat each button press how many times?

The number of times Enterprise TV should rapidly repeat a single button press to ensure that the set-top box receives it. Increase this number if the set-top box is not receiving digits, and decrease it if the set-top box is receiving duplicate digits:

Symptom Solution

Slow channel-changing speed Lower Value Receiver intermittently misses transmissions Increase Value Receiver duplicates button presses Lower Value