If your SnapStream Enterprise TV Server was provided with rackmount rails, install those on server unit and then install the SnapStream Enterprise TV Server in your server rack.
1. Pull the center slide out until the rail is fully expanded.
2. You will see a black plastic tab where the center slide joins the rest of the rail assembly. Press this tab tot he right to release the center slide. Remove the slide from the rail assembly.
3. Attach one center slide to each side of the Enterprise Server using the screws provided and the existing holes in the server chassis. The open ends of the slides should face the rear of the server.
4. Attach the rack mounts to either end of the rail assembly using the screws and nuts provided.
5. Install the rail assembly in your server rack using the screws provided.
6. Carefully life the server and insert the ends of the center slides into the rail assembly. The server should slide in and out smoothly on the rails.
