External Tuning Testing

This screen of the Setup Wizard is used to test whether the external tuning device is properly tuning (changing channels on) the receiver box.

To begin, point the IR Blaster at the receiver box like a remote control, and click "Run Test." The testing apparat will attempt to tune to a series of numbers.

The receiver is properly tuning from the external tuning device if the channel displayed in the Setup Wizard test appears on the receiver's LCD display or television. If the receiver does not have a display or there is no way of seeing to what channel the receiver is tuning, such as on a television, it will be unable to test properly until the "Testing" section (which tests audio, video, and channel changing ability), which occurs later in the wizard..

If channels are not changing on the receiver box as a result of the test, the test failed:

1.

Hit the "BACK" button until the Wizard is displaying the "Select Remote Model" screen.

2.

Select the newly created profile from the list, which will be named as specified in the "Advanced Tuning Settings" step.

3.

Hit NEXT to get to the advanced tuning settings section. Note: We suggest changing only one advanced setting at a time before testing again.

4.

Adjust the provided values according to the guidelines.

When finished, return to this screen to begin testing again.

When the test is successful, hit NEXT and the following screen will appear:


Hit NEXT and proceed to the next section of this document, "Select Audio Device."