Training

Note: This screen will not appear unless "Unlisted Remote" was selected on the "Select Remote Model" screen.

This screen enables the user to "train" Enterprise TV to use the IR Blaster by using the set-top box's remote control.

Select the IR Blaster labeled 1&2. Set the remote control and IR Blaster on a flat surface about six inches (approx. 15cm) apart. Point the remote at the IR Blaster's front and hit the "Train" button to begin. Follow the instructions in the box in the middle of the screen. Once each of the boxes contains a check mark, Enterprise TV has been trained with the appropriate frequencies. If necessary, hit the "Reset" button to start over.

The LED on the IR Blaster should flash when the remote's buttons are pressed. If you are using multiple IR Blasters, other IR Blasters may or may not flash as well; either result is normal.

It may take up to a minute for some key presses to be detected. If it takes longer than that, try varying the distance between the remote and the IR Blaster, and press the appropriate button again.

Once all of the buttons have been detected, click NEXT. Proceed to External Tuning Testing.